Murphy's Law states: "Anything that can go wrong will go wrong." This is especially true and especially painful when there is an audience involved.

Categories

Archives

This blog was active from April, 2008 to July 2012.
It is no longer being updated. It will continue to be maintained for reference purposes.

Things to Think About #1: Sockets

Sometimes, you’re working in an old venue. Real old. Rooms that have seen hundreds if not thousands of meetings, speeches, dances, rallies, fund raisers, etc. Old things can be well worn. Worn in ways that aren’t obvious.

For instance, there was a chain hotel in Bethesda that we used to use a lot that was old but seemed to be aging well. It looked like the ballroom had been renovated at some point. Newish carpeting, reasonably fresh wallpaper and paint. High tech climate control that kept things too cold digitally. The works. However, the electrical outlet must have been overlooked.

We didn’t need a high-voltage power drop. We only had a our laptops, a switch and a couple projectors so we just plugged into the regular wall sockets. Or at least we thought we did.

This socket had been plugged into thousand of times over the years and there just wasn’t enough friction in there to ensure that what was plugged in would remain plugged in. The weight of the cable pulled the plug half way out of the wall as soon as I let go of it. It wouldn’t stick.

This, of course, could be very bad for our stuff.

We ended up securely taping the cord to the wall just below outlet. No biggie.

Always, always have a roll of gaffer’s tape with you when you’re working.

Bookmarked: Gaffing cable to the floor – ControlBooth

Gaffing cable to the floor – ControlBooth – "So, while this may seem nit picky, in the end I say spend a little more time and gaff your cables right the first time around. A good job will save time both during the run and strike, and help keep cables safe backstage."